Modify Sas Port Parameters - Fujitsu ETERNUS DX S5 Series Configuration Manual

7. Host Interface Management
Modify Port Parameters

Modify SAS Port Parameters

This function sets the parameters for the SAS host interface port that connects between the ETERNUS DX and the
host.
Caution
• This host interface is supported only for the ETERNUS DX60 S5/DX100 S5/DX200 S5.
• When changing port parameters during operation, stop access from the server that is connected to the
target port. Host access does not need to be stopped to change the port parameters of newly added
Channel Adapter (CA) ports.
The procedure to set SAS port parameters is as follows:
1
Select the SAS port to set the parameters for (multiple selections can be made) and click [Configure SAS
Port] in [Action].
The [Modify SAS Port Parameters] screen appears.
Note
Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port. After
the specification is complete, click the [Modify] button.
143 Configuration Guide (Basic)