Figure 52 Controller (For The Eternus Dx100 S5/Dx200 S5, Pattern 1); Figure 53 Controller (For The Eternus Dx100 S5/Dx200 S5, Pattern 2); Table 22 Status And Meaning Of Each Led (Controller For The Eternus Dx100 S5/Dx200 S5) - Fujitsu ETERNUS DX S5 Series Configuration Manual

A. Component Names
Controller Enclosure
LED name
READY/FAULT
CA FAULT
MASTER
●
ETERNUS DX100 S5/DX200 S5
Figure 52
DI (OUT) LINK/FAULT LED
LINK/FAULT LED
CA#0 FAULT LED
IDENTIFY/BBU FAULT LED
Figure 53
DI (OUT) LINK/FAULT LED
CA#0 FAULT LED
IDENTIFY/BBU FAULT LED
LINK/FAULT LED
Table 22 Status and Meaning of Each LED (Controller for the ETERNUS DX100 S5/DX200 S5)
LED name
IDENTIFY/BBU FAULT
LED status
(green)
(blinks green)
(amber)
(blinks amber)
(amber)
(green)
Controller (for the ETERNUS DX100 S5/DX200 S5, Pattern 1)
LAN ACT LED
LAN LINK LED
Controller (for the ETERNUS DX100 S5/DX200 S5, Pattern 2)
LAN ACT LED
LAN LINK LED
LED status
(blinks blue)
(amber)
Meaning
The controller is in normal status.
An error has occurred during startup.
• The controller is performing the initial setup after the power is
turned on.
• The controller is in error status.
The host interface is in error status.
The controller is set as a Master CM.
READY/FAULT LED
CA#1 FAULT LED
MASTER LED
Meaning
The installation location of the controller is identified according to
the instruction that is issued from ETERNUS Web GUI or ETERNUS CLI.
The battery is in error status.
231
READY/FAULT LED
CA#1 FAULT LED
MASTER LED
LAN LINK LED
LAN ACT LED
LINK/FAULT LED
LAN LINK LED
LAN ACT LED
LINK/FAULT LED
Configuration Guide (Basic)