Fujitsu ETERNUS DX S5 Series Configuration Manual page 38

3. Rack Installation
Drive Enclosure Installation
Note
Make sure to attach the rack rails to rack pillars so that they fit exactly together without any space
between them.
Plate
M5 screw
(Rack pillar: front)
The M5 screw positions for the rack rails are determined by the drive enclosure base line.
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in the 2nd
and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
Sixth screw
(M5 screw)
First screw
(M5 screw)
Fifth screw
(M5 screw)
Second screw
(M5 screw)
3
Tighten the M4 screws of the rack rails that were slightly unscrewed in
4
Install the drive enclosure in the rack.
Rack rail (left)
Plate
M5 screw
Front view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Rear view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
• When installing or removing the drive enclosure to or from the rack, make
sure that the sides and the bottom of the drive enclosure are held by two or
more people. Failure to do so may cause injury.
M5 screw
Washer
(Rack pillar: rear)
Rack rail (right)
[Right]
Sixth screw
(M5 screw)
First screw
(M5 screw)
[Right]
Fifth screw
(M5 screw)
Second screw
(M5 screw)
38
M5 screw
Washer
Step 1.
Configuration Guide (Basic)