Initial Setup 2 (Optional) - Fujitsu ETERNUS DX S5 Series Configuration Manual

5. General Settings
Initial Setup

Initial Setup 2 (Optional)

This section explains Initial Setup 2.
Initial Setup 2 sets the various reports that are generated when an error occurs in the ETERNUS DX.
If monitoring the ETERNUS DX, use this wizard to build an environment.
The flow of wizard operations in Initial Setup 2 is shown below.
Refer to "System Settings" in "ETERNUS Web GUI User's Guide" for details.
Note
Some items do not need to be specified depending on the Simple Network Management Protocol (SNMP
version).
1
Set Date and Time
Set the date/time and time zone (ETERNUS DX location) of the internal clock in the ETERNUS DX.
2
Setup SNMP Agent Basic Interface
Set up the SNMP Agent basic interface in the ETERNUS DX.
3
Setup SNMP Manager
Specify the IP address of the SNMP Manager.
4
Setup SNMP Agent MIB Access View
Set the MIB View of the SNMP Agent.
5
Setup SNMP Agent User
Set up the user which accesses the SNMP Agent.
The security level and the MIB access range are configured for each user.
Note
This setting is not required when SNMPv1 or SNMPv2c is used for SNMP communication.
6
Setup SNMP Agent Community
Set up the SNMP Agent Community.
Note
This setting is not required when SNMPv3 is used for SNMP communication.
7
Setup SNMP Agent Trap
Set up the environment to send notification of events that occur in the ETERNUS DX to the SNMP Agent
Manager by an SNMP Trap.
8
Setup E-Mail Notification
Set the E-mail notification for events that occur in the ETERNUS DX.
9
Setup Syslog
Set the external servers (Syslog server) for sending logs of events that are detected by the ETERNUS DX.
85 Configuration Guide (Basic)