Component Names And Led Names; Figure 27 System Operation Panel; Table 12 Status And Meaning Of Each Led (System Operation Panel) - Fujitsu ETERNUS DX S5 Series Configuration Manual

A. Component Names
Frontend Enclosures (ETERNUS DX900 S5)

Component Names and LED Names

This section describes the operation panel of the frontend enclosure.
■
System Operation Panel
The system operation panel on the front of the frontend enclosure has LEDs, an LCD panel, panel keys, and a
Power switch.
Figure 27 System Operation Panel
1
LEDs
(Refer to "● LEDs" (page
2
LCD panel
(Refer to "● LCD Panel" (page
3
Panel keys
(Refer to "● Panel Keys" (page
4
Power switch
(Refer to "● Power Switch" (page
●
LEDs
LEDs are lamps that indicate the status of the ETERNUS DX.
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 12 Status and Meaning of Each LED (System Operation Panel)
LED name
POWER
IDENTIFY
FAULT
1 2
207).)
208).)
210).)
210).)
LED status
(green)
(blinks blue)
(amber)
(blinks amber)
4
POWER LED
3
Meaning
Power is supplied.
The installation location of the frontend enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI or
ETERNUS CLI.
The ETERNUS DX is in error status.
A part of the ETERNUS DX requires preventive maintenance.
207 Configuration Guide (Basic)