Wake On Lan Settings - Fujitsu ETERNUS DX S5 Series Configuration Manual

9. Power Control Setup

Wake On LAN Settings

Wake On LAN Settings
A network environment needs to be set to receive magic packets that are used by Wake On LAN for the ETERNUS
DX.
The procedure to set Wake On LAN is as follows:
1
On the navigation of the ETERNUS Web GUI screen, click [System].
The [System] screen appears.
2
In [Category], click [Network].
The [Network] screen appears.
3
In [Action], click [Setup Network].
The [Setup Network Environment] screen appears.
4
In the [Setup Network Environment] screen, select [Enable] for [Wake on LAN].
• For operations with cluster connections, set the IP address of the Slave CM for the "Slave IP Address" of
the MNT port.
• To control power supply with servers in a network to which the ETERNUS DX does not belong, set
"Gateway" and specify the server IP address or the network address in "Allowable IP Address".
5
Click the [Set] button.
A confirmation screen appears.
6
Click the [OK] button.
The network environment settings are applied.
7
Check the setting completion message and click the [Done] button.
The screen returns to the [System Settings] screen.
181 Configuration Guide (Basic)