Fujitsu ETERNUS DX S5 Series Configuration Manual page 71

5. General Settings
Powering On
• If the REMOTE LED (
unit.
• After power-off, wait for about one minute before turning power on again.
• If the ETERNUS DX turns off abnormally due to problems such as a power failure, it takes approximately
10 minutes (max.) longer for the ETERNUS DX60 S5/DX100 S5/DX200 S5 and the ETERNUS DX500 S5,
approximately 15 minutes (max.) longer for the ETERNUS DX600 S5, or approximately 20 minutes
(max.) longer for the ETERNUS DX900 S5 to reach the READY state the next time the ETERNUS DX is
turned on.
1
Press the Power switch of the controller enclosure or the frontend enclosure.
Controller enclosure
Frontend enclosure
The POWER LED (
) of the ETERNUS DX is green, turn on the ETERNUS DX via a power synchronized
Power switch
ETERNUS DX60 S5/DX100 S5/DX200 S5
Power switch
ETERNUS DX900 S5
or ) on each enclosure is turned on.
Power switch
ETERNUS DX500 S5/DX600 S5
71 Configuration Guide (Basic)