Figure 55 Controller (Eternus Dx600 S5); Table 23 Status And Meaning Of Each Led (Controller For The Eternus Dx500 S5/Dx600 S5) - Fujitsu ETERNUS DX S5 Series Configuration Manual

A. Component Names
Controller Enclosure
Figure 55
BUD READY LED
BUD FAULT LED
READY/FAULT LED
IDENTIFY LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 23 Status and Meaning of Each LED (Controller for the ETERNUS DX500 S5/DX600 S5)
LED name
READY/FAULT
IDENTIFY
LAN LINK
LAN ACT
MASTER
DI (OUT) LINK/FAULT
BUD READY
BUD FAULT
Controller (ETERNUS DX600 S5)
LED status
(green)
(blinks green)
(amber)
(blinks amber)
(blinks blue)
(green)
(blinks green)
(green)
(green)
(amber)
(blinks amber)
(green)
(amber)
DI (OUT) LINK/FAULT LED
MASTER LED
LAN ACT LED
LAN LINK LED
Meaning
The controller is in normal status.
An error has occurred during startup.
The controller is in error status.
•
An error has occurred during startup.
•
The installation location of the controller is identified according to
the instruction that is issued from ETERNUS Web GUI or ETERNUS CLI.
The link between the LAN port and the destination port has been
established.
Data is being sent or received via the LAN port.
The controller is set as a Master CM.
The link between the DI (OUT) port and the destination port has been
established.
• The link between the DI (OUT) port and the destination port is in
error status.
• The ports to remove the cables between enclosures from are
indicated. This occurs while a drive enclosure is being added.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
The BUD is in normal status.
The BUD is in error status.
233 Configuration Guide (Basic)