Installing The Tn2302Ap Ip Media Processor; Connect The Cables For Tn799Dp; Connect The Cables For Tn2302Ap; Connect The Ethernet - Avaya S8700 Manual

90
Installing the S8700 IP Connect
TN2302AP Amphenol Adapter
Figure notes
1

Installing the TN2302AP IP Media Processor

Connect the cables for TN799DP

Determine into which port slots you are putting the TN799DP C-LAN circuit packs.
1
From the rear of the media gateway:
2 Connect a 259A connector to the Amphenol connector corresponding to each TN799DP
slot.
Connect one end of each DW8 cable to each 259A connector.
3

Connect the cables for TN2302AP

Determine into which port slots you are putting the TN2302AP IP Media Processor
1
circuit packs.
From the rear of the media gateway:
2 Connect the amphenol connector on the adapter to the Amphenol connector
corresponding to each TN2302AP slot.

Connect the Ethernet

1 Connect the network cable(s) to the ETHERNET connector on the TN2302AP backplane
adapter(s).
NOTE:
You need a CAT5 or better cable for 100-Mbyte operation.
addfipm2 KLC 083000
Amphenol connector to backplane
connector corresponding to
TN2302AP slot
3
1
2 To network
9-pin connector for
3
maintenance
May 2002
2