Configure The Cajun Ethernet Switch (If Used) - Avaya S8700 Manual

19 Repeat steps 5 thru 18 for the UPS 2 SNMP module. Use the following address and
netmask information:
UPS IPaddress / Subnet mask = 198.152.255.239 / 255.255.255.0
•
• Default Gateway IP address = 198.152.255.202
Host Table trap receiver IP address = 198.152.255.202
•
• Local network administrator supplied information as required.

Configure the Cajun Ethernet Switch (if used)

NOTE:
These instruction apply only if using a Cajun Ethernet switch.
The SNMP subagent in the Ethernet switch must be administered so it can report alarms to the
appropriate media server when the hardware experiences problems. Refer to the Job Aid
entitled Pre-Installation Network Worksheet—S8700 IP Connect
and community strings. At a minimum, the following items need to be configured:
IP address (1 for each equipped Ethernet switch)
•
• Subnet mask
Community string (get, set, trap)
•
Refer to the configuration section of the user guide that comes with the Ethernet switch for the
default user ID, password and configuration commands. Use the following general procedures
to administer the Ethernet switch(es):
Plug the Ethernet switch into a nonswitched wall outlet or a UPS.
1
2 Connect the services laptop computer (RS-232 serial port) to the port labeled Console on
the front of the Ethernet switch using the cable supplied with the Ethernet switch.
3 Open a terminal emulation program (such as HyperTerminal).
Administer the terminal emulation port settings:
4
9600 baud rate
•
• No parity
8 bits
•
1 stop bit
•
5 Log into the Ethernet switch with the appropriate login and password. Refer the user
guide supplied with the Ethernet switch.
6 Using the Command Line Interface (CLI) of the Ethernet switch set the following
parameters:
• IP address and subnet mask of the Ethernet switch.
• IP address of the Trap Receiver
SNMP community string for Get, Set, and Trap.
•
May 2002
Installing the S8700 IP Connect
for the proper addresses
33