Verify Server 1 Connection To Customer's Lan - Avaya S8700 Manual

26
Installing the S8700 IP Connect

Verify Server 1 Connection to Customer's LAN

The following administration uses the services laptop computer and the media server web
interface. You also need a customer representative with knowledge of the customer's LAN
configuration and access to a computer on their network.
1 Connect a customer-supplied CAT5 cable from server 1, port Eth0, to the customer's
LAN. Refer to
Configurations.
Click Execute Ping.
2
Have the customer representative type in the name, if DNS is administered, or IP address
3
of a computer on the network to verify that the server is connected to the customer's
network.
Verify that the ping was successful.
4
Have a customer representative do the following test from a computer on their network:
5 Click Start > Run to open the Run dialog box.
Type command to open an MS-DOS command window.
6
7 Type ping <active server name>, if DNS is administered, or ping <active server ip
address>.
Verify that the ping was successful.
8
Getting Started with the Avaya™ S8700 Media Server for IP Connect
May 2002