Avaya S8700 Manual page 32

32
Installing the S8700 IP Connect
3 Administer the emulation program port settings:
4 Press
does not appear, press
Type BR 0 and press
5
6 Type IP 198.152.254.239 and press
Type NM 255.255.255.0 and press
7
Type GW 198.152.254.201 and press
8
NOTE:
If a Network Management System (NMS) is going to monitor the UPS units, coordinate
the assignment of community names with the LAN administrator (refer to the Job Aid
entitled
going to monitor the UPSs, set the community names to unique string values.
If supplied, enter the Get and Set community names with the following commands:
9
10 Type HS and press
NOTE:
The Host Table should be empty. If not, in the following commands use a host table entry
that is currently unassigned.
11 Type HI1 198.152.254.201 and press
12 Type TL1 3 and press
Type TT1 1and press
13
14 Type HS and press
15 Type CF and press
Type SA and press
16
17 When completed, disconnect the services laptop computer from the UPS.
Connect one end of a CAT5 cable to the RJ45 connector on the UPS 1 SNMP module
18
and the other end to the next available port on an Ethernet switch.
• 9600 baud rate
No parity
•
• 8 bits
1 stop bit
•
The Main Configuration screen appears. If the Main Configuration screen
Enter.
Enter
(Sets the BOOTP retry counter to zero.)
Enter.
Pre-Installation Network Worksheet—S8700 IP
• Type CG name and press
alphanumeric characters fo the name. The name field is case sensitive and cannot
contain blanks.)
Type CS name and press
•
alphanumeric characters for the name. The name field is case sensitive and cannot
contain blanks.)
(Displays the Host Table)
Enter.
Enter.
Enter.
Verify the table entries. (Redisplays the host table)
Enter.
(Redisplays the basic administration screen)
Enter.
(Saves configuration and restarts module)
Enter.
again.
. (Default IP Address for this UPS)
Enter
. (Default subnet mask for this UPS)
Enter
. (Default gateway for this UPS)
Enter
(Enters the Get community name. Type up to 16
Enter.
(Enters the Set community name. Type up to 16
Enter.
(Sets the trap destination for this UPS)
Enter.
(Sets the trap level for the host, All traps)
(Sets the trap type, Standard UPS MIB-defined)
May 2002
Connect). If an NMS is not