Set Up Avaya Site Administration-Over The Network; Launching Asa; Input Translations; Reset Media Server - Avaya S8700 Manual

Set up Avaya Site Administration—over the
network
The following administration is done on a computer connected to the customer's LAN. The
ASA switch record to connect to the active server will be unique for each customer.
1 On the media server web interface, click Download ASA to download Avaya Site
Administration l.11 to your computer.
2 Follow the steps in the Setup Wizard to install ASA on your computer.
NOTE:
The following procedure establishes a switch record for use when connected to the
dedicated Avaya Services port. If this switch record already exists (from a previous
installation) this procedure is not required.
On your computer launch Avaya Site Administration
3
4 Click on File > New > Switch.
Follow the Add Switch wizard to build a switch record for the current customer.
5
Give the switch record a name that indicates it will work with all Avaya S8700
•
media servers, such as S8700-Service-Port
Select Network Connection as the connection method
•
• Use IP address 192.11.13.6
• Use port 5023
When the switch record is established, test it by connecting to the media server.
6

Launching ASA

1 Click Start ASA to launch Avaya Site Administration on your computer.
When prompted, log in.
2

Input Translations

Contact the installation personnel responsible for translation input to download translations. If
the translations are not ready, you may continue with the process, entering minimal translations
to verify connectivity to the port networks.

Reset Media Server

NOTE:
Do not reset the media server if no translations were input.
The following administration uses the services laptop computer connected to the active media
server and uses Avaya Site Administration.
1 If not already open, launch Avaya Site Administration.
Log into the active media server as craft.
2
May 2002
Installing the S8700 IP Connect
35