Test Expansion Interface Exchange For Each Port Network (S8700 Multi-Connect Only) - Avaya S8700 Manual

194
Installing the S8700 IP Connect
Test Expansion Interface Exchange for Each Port
Network (S8700 Multi-Connect only)
If the configuration is critical reliability, test the expansion interface exchange for each Port
Network (PN).
1 Type status port-network number <1-64> and press
This displays the standby expansion link. See
Expansion Link is Set—S8700 Multi-Connect'' on page
Type set expansion-link UUCSS, where UUCSS is one of the cabinet, carrier, and port
2
locations of the standby expansion link, and press
3 Verify the bottom of the screen displays:
Command successfully completed
4 Type status port-network number <1-64> and press
A screen similar to
Multi-Connect'' on page 195
5 Verify that the MODEs of the expansion links have changed.
If any problems are indicated, check the TDM cables and the inter-cabinet cables (ICC)
6
in the associated port network.
Sample of Port Network Status before Expansion Link is Set—S8700 Multi-Connect
status port-network
PN Alarms
1
TDM Service Control Dedicated
Bus State
A
B
''Sample of Port Network Status after Expansion Link is Set—S8700
PORT NETWORK STATUS
Major Minor Warning
Alarms Alarms
0 1 19
Channel Tones
in n n
in y y
Service
PKT State
1 in
''Sample of Port Network Status before
Enter
displays.
Carrier PNC Status
Locs Active Standby Conn
01A up 2
01B 1
01C
01D
TONE/ Service
CLOCK State
01A
01B
Major Minor Bus
Alarms Alarms Faults
n n 0
May 2002
.
E nter
194.
.
.
Enter
ATM PNC
Endpoints
A-PNC 01D01-AT02A active
A-PNC 01C01-AT01A active
System System
Clock Tones
in standby standby
in active active
Open Bus
Leads
0
Mode