S8700 Media Server Leds; Testing The Media Server Leds - Avaya S8700 Manual

S8700 Media Server LEDs

The media server has the LEDs shown in
179:
LEDs on front and back of media server
scdlled KLC 030502
Figure notes
1 Power
2 Configuration fault
Hard drive activity
3
4 Network activity (CNA)
5 Service—configuration health
Active or standby mode indicator
6

Testing the Media Server LEDs

You can test some of the LEDs on the front of the media server through the media server web
interface. This makes sure that the
server) and the transmit LED on the DAJ1 duplication memory card (on the back of the media
server) are controllable and not burned out and that the media server is not hung.
NOTE:
The U2 LED is controlled by the S8700 Media Server but does not have an assigned
function.
The other LEDs are exclusively under hardware control so will not flash during the test. Refer
to the OEM user documentation that comes with the media server for information on those
LEDs.
''LEDs on front and back of media server'' on page
1 2
SERVICE ACTIVE
1 U2
STANDBY
3 4 4 5 6 7
2
1
7 U2 (not defined)
8 4 NIC ports (the numbers indicate
their assigned Ethernet ports)
9 LEDs for the NIC ports
LEDs for fiber optic duplication
10
connectivity
11 Status LED (not used)
Active/Standby and U2 LEDs (on the front of the media
May 2002
Installing the S8700 IP Connect
8
5 5 4 4 3 3 2 2
9
10
11
179