TDM/LAN bus cable routing slot plate removal
1
Figure notes
Media gateway B routing
1
slot plate
Pull open the EMI Gasket, and pass the TDM/LAN bus cable through the routing slots in
5
both media gateways. Push the free end of the EMI Gasket back in place. Make sure the
open corner of the gasket faces the rear of the media gateway. Once installed, the top
media gateway should rest on and compress the gasket. See
routed through the media gateway'' on page
B
A
2
Media gateway A routing slot plate
2
May 2002
Installing the S8700 IP Connect
1
2
''TDM/LAN bus cable
62.
61