Check Circuit Pack Configuration - Avaya S8700 Manual

190
Installing the S8700 IP Connect
Sample Port Network Status Screen for Cabinet 1—S8700 Multi-Connect
status port-network 1
PN Alarms Alarms Alarms
1
TDM Service
Bus
A
B
Command:

Check Circuit Pack Configuration

The list configuration report provides a list of circuit packs connected to the configuration and
recognized by the software.
1 Type list configuration all and press
Verify the screen displays list configuration similar to
2
Screen — Page 4, S8700 Multi-Connect'' on page
communicating with each circuit pack (except power supply circuit packs). Do not
attempt to correct any problems until after the diagnostic tests that you run later in the
configuration tests.
Note any boards with a VINTAGE column entry of NO BOARD or CONFLICT.
3
4 A u indicates unassigned ports, and a number indicates the port has been translated.
Major Minor Warning Carrier
Locs
1 0 195 01A
01B
Control Dedicated
State Channel Tones
in y n
in n y
Service
PKT State
1 in
PORT NETWORK STATUS
PN Control
Active Standby
up up 1
TONE/
CLOCK
01B
01A
Major Minor Bus
Alarms Alarms Faults
n n 0
.
Enter
191. Make sure the software is
May 2002
FIBER-
LINK Endpoints Mode
B-PNC 01B02-03E04 standby
1 A-PNC 01A01-01E04 active
Service System System
State Clock Tones
in standby standby
in active active
Open Bus
Leads
0
''Sample System Configuration