Mounting The 1145B2/1146B2 Power Supply - Avaya S8700 Manual

148
Installing the S8700 IP Connect
• Do not attempt to recharge batteries on your own. The batteries may leak corrosive
electrolyte or explode. The 1145B2 power unit recharges the batteries safely.
• Remove the batteries if the power unit will not be used for a long period of time (several
months or more) since during this time the battery may leak.
Discard discharged batteries as soon as possible. Discharged batteries are more likely to
•
leak.
Do not store batteries in high temperature areas. Batteries stored in a cold environment
•
should be protected from condensation during storage and warming. Batteries should be
stabilized at room temperature prior to use after cold storage. Do not install batteries if
the manufacturing date on the label indicates that the batteries are more than six months
old.

Mounting the 1145B2/1146B2 Power Supply

''1145B2/1146B2 Mounting Arrangement'' on page 149
and wall-mounting plates fit together.
the expanded power supply components (power distribution unit and "T" cable).
A manual switch on the distribution unit allows the user to redirect reserve power to outputs 1
through 32 so all outputs are provided battery reserve power, or to outputs 1 through 8 to
provide high power above 6.25 watts.
NOTE:
The switch must be set to the 1-32 position.
The 1145B22/1146B2 is a -48V power supply with 275 watts total output. Each output circuit is
current limited by a Polymer Positive Temperature Coefficient Resistance Device (PTC) that
limits the maximum output to 12 watts. Each 1146B2 output has an LED to indicate the status
of the PTC. If the LED is on, the PTC has a short on that power pair.
Not all outputs can simultaneously provide 12 watts. The average power per output cannot
exceed 8.6 watts (275/32 = 8.6). The 1145B22 is designed to power one ISDN terminal or DCP
adjunct per output. The maximum number of terminals or adjuncts is 32 at less than or equal to
6.25 watts each. The 1145B22 is required for installations outside the United States.
Auxiliary power (local or bulk) is always required for the following:
Attendant Console 302C1
•
Any 8520 terminal
•
• Any 7500- or 8500-series terminal with an asynchronous data module
Any 7500-series terminal whether in passive bus, or point to point (one per BRI port)
•
• Any 8510 terminal in passive bus or with an asynchronous data module (unless the 8510
will not be used to support data or video)
PassageWay adapter interface
•
• Some 8400-series terminal and adjuncts
Some 7400-series terminal and adjuncts
•
shows how the standard power supply
''Expanded Power Distribution Unit'' on page 150
May 2002
shows