Correct Shipping Errors; Set The Carrier Address Id - Avaya S8700 Manual

Comcodes for equipment used with Avaya G600 — Continued
Comcode Description
105514756 3C1S Analog Line Protector - Solid State
102904893 4B1C Carbon Block with Heat Coil
104401856 4B1E-W Wide Gap Gas Tube w/Heat Coil
104386545 4C1S Analog Line Protector - Solid State with Heat Coil
105581086 4C3S-75 Digital Voice Circuit Protector - Solid State
406144907 ITW LINX Gas Tube, Avalanche Suppress
901007120 ITW Linx Ground Bar (used with above)
406304816 ITW Linx Replacement Fuse
103972758 Data Link Protector (1 circuit)
103972733 Data Link Protector (8 circuits)
407063478 Electrostatic Discharge (ESD) Wrist Strap

Correct Shipping Errors

Red-tag all defective and over-shipped equipment and return according to the nearest
1
Material Stocking Location (MSL) instructions.
Direct all short-shipped reports to the nearest MSL. Contact the appropriate location for
2
specific instructions. For streamlined implementation, call 1-800-772-5409.

Set the Carrier Address ID

Set the Carrier Address ID either before or after installing each media gateway.
Loosen the thumb screws on the fan assembly and pull it straight out as shown in
1
assembly removal'' on page
installed in the rack.
46. Leave the fan assembly off until the unit is completely
May 2002
Installing the S8700 IP Connect
Optional
X
X
X
X
X
X
X
X
X
X
''Fan
45