Install The Circuit Packs - Avaya S8700 Manual

Install the circuit packs

!
CAUTION:
When adding or replacing any hardware, be sure to ground yourself against electrostatic
discharge (ESD) by wearing a grounded wrist strap.
NOTE:
The TN799DP and TN2302AP circuit packs are hot-swappable, so you do not need to
power down the media gateway to install them.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
Use Avaya Site Administration for the administration.
Insert the TN799DP circuit pack into the port slot identified earlier.
1
2 Insert the TN2302AP IP Media Processor into the port slot you reserved for it and seat it
properly (See ''TN2302AP IP Interface faceplate'' on page
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The
RED LED stays on until an IP address is assigned to the circuit pack.
Log in as craft.
3
4 Type list configuration all and press
recognizes the TN2302AP circuit packs.
to verify that the MultiVantage software
Enter
May 2002
Installing the S8700 IP Connect
92).
91