Test The Ip Connections - Avaya S8700 Manual

Administer the data module
1 Type add data-module extension and press
The Data Module screen appears. Use this screen to administer the data module that is
associated with the TN2501AP ethernet port.
add data-module 30006
Data Extension: 30006
Type: ethernet
Port: 1b0333
Link: 5
Network uses 1's for Broadcast Addresses? y
2 Set the Type field to ethernet.
Set the Port field to correspond to the circuit pack location.
3
The port number (final two digits) is always 33 for the TN2501AP circuit pack.
4 Set the Link field to an unassigned or next-available link number.
Set the Network uses 1's for Broadcast Address field according to the your network
5
requirements.
6 Type a unique name in the Name field.
Press to save your changes.
7
En te r
Administer IP routing (if used)
1 Type add ip-route and press
Administer IP routes to the TN2501AP circuit pack.
2
Press to effect the changes.
3
En te r

Test the IP connections

Click Start > Run to open the Run dialog box.
1
Type command and press
2
3 Type ping <ipaddress>, where <ipaddress> is a known computer on the network and
press to verify connectivity.
Enter
4 Using ASA, type status link to test the new IP connections that you have administered.
.
E nte r
DATA MODULE
Name: VAL#2 Data Module
.
E nte r
to open an MS-DOS window.
Enter
May 2002
Installing the S8700 IP Connect
Page 1 of 1
103