Cabling 2 Media Gateways - Avaya S8700 Manual

60
Installing the S8700 IP Connect

Cabling 2 Media Gateways

1 Remove the bottom panel from media gateway B.
If not already removed, remove the fan assemblies from media gateways A and B.
2
3 Remove the right TDM/LAN bus terminator from media gateway A, and install it at the
left end of the TDM/LAN bus on media gateway B. See
terminator from media gateway A to media gateway B'' on page
!
WARNING:
Make sure to install the TDM/LAN bus terminators with the arrow on the back pointing
upward.
Shift TDM/LAN bus terminator from media gateway A to media gateway B
Figure notes
1
Remove the nuts on the posts of the plates covering the bottom right TDM/LAN cable
4
routing slot of media gateway B and the top right TDM/LAN cable routing slot of media
gateway A. See
2
EMI Gasket between media gatewasys
''TDM/LAN bus cable routing slot plate removal'' on page 61
2
2
2
May 2002
''Shift TDM/LAN bus
60.
1
cadptdm2 KLC 102600
TDM/LAN bus terminators
B
A