Configuring The Hardware In The Rack; Configure The Media Servers - Avaya S8700 Manual

Configuring the Hardware in the Rack

This section covers the following tasks:
• ''Configure the Media Servers'' on page 17
• ''Configure the UPSs'' on page 31
''Configure the Cajun Ethernet Switch (if used)'' on page 33
•

Configure the Media Servers

Once the hardware is installed you must configure the two servers, install the license and Avaya
authentication files, and test the connectivity to the customer's LAN. You configure the first
server, verify its operation, then configure the second server and verify its operation.
Connect the services laptop computer to the services port (default is port 2 [Eth1]) on the back
of the servers using the black crossover cable.
This section covers the following tasks:
''Configure Server 1'' on page 18
•
• ''Install License and Avaya Authentication Files'' on page 23
''Verify Server 1 Connection to Customer's LAN'' on page 26
•
''Test Server 1 LEDs'' on page 27
•
• ''Set SNMP Traps'' on page 27
''Verify Date and Time'' on page 28
•
• ''Connect Duplication Cables'' on page 28
''Configure Server 2'' on page 28
•
''Verify Server 2 Connection to Customer's LAN'' on page 30
•
• ''Test Server 2 LEDs'' on page 30
''Busy Out Standby Server'' on page 30
•
• ''Set up Avaya Site Administration—dedicated services port'' on page 34
• ''Set up Avaya Site Administration—over the network'' on page 35
''Launching ASA'' on page 35
•
• ''Input Translations'' on page 35
• ''Reset Media Server'' on page 35
''Add Media Gateways'' on page 36
•
• ''Administer the IP Server Interface'' on page 37
May 2002
Installing the S8700 IP Connect
17