Creating The Numbering Plan - ASCOM Ascotel 2025 System Manual

These properties are set in the configuration for the routes. Variant 1:
1. In system 1 select the settings for route 1-1:
– Numbering plan identifier (NPI) = E.164
– Digit barring = yes
2. In system 2 select the settings for route 2-1:
– Numbering plan identifier (NPI) = E.164
– Digit barring = yes
3. In system 3 select the settings for route 3-1:
– Numbering plan identifier (NPI) = E.164
– Digit barring = yes
Variant 2:
1. In system 1 select the settings for route 1-1:
– Numbering plan identifier (NPI) = E.164
– Digit barring = yes
2. In system 2 select the settings for route 2-1:
– Numbering plan identifier (NPI) = PNP
– Send access code = 0 (as the exchange access prefix)
– Digit barring = yes
3. In system 3 select the settings for route 3-1:
– Numbering plan identifier (NPI) = PNP
– Send access code = 0 (as the exchange access prefix)
– Digit barring = yes
6.2.4

Creating the Numbering Plan

Now that the network is defined through the definition of the routes and trunk
groups, we need to specify the numbering within the network.
In the following we shall be looking at both methods described on Page 3.102.
HBT_20321104_03/B0_en
ascom Ascotel 2025/2045/2065
Planning a Private Network 3.115