Ascotel Dect Configuration - ASCOM Ascotel 2025 System Manual

5.4

Ascotel DECT Configuration

Once the DECT radio units have been installed, complement the system configu-
ration. If the system is being configured for the first time, steps 1 and 2 are already
covered by the preceding section.
1. Complement the numbering plan with the Ascotel DECT subscriber numbers.
Note:
After the system initialization the radio unit starts in status "AD2 ok". It
is operational only once at least one DECT subscriber is entered in the
numbering plan (see "Self-test for the DECT System", Page 7.64).
2. Define the subscriber data under "SC configuration" (names, authorizations,
unobtainable destination, etc.)
3. Set the Ascotel DECT system parameters under "System settings".
4. Name the radio units.
5. Log on the DECT handsets.
6. Define the logon period for visitors' handsets (if required).
For details, see "Part 3: Planning".
HBT_20321104_05/B0_en
ascom Ascotel 2025/2045/2065
Configuration Steps 5.27