Before Starting Service Work - Fuji Xerox DocuPrint M355df Service Manual

Chapter 4 Disassembly / Assembly and Adjustment
4.1 Preface

4.1.2 Before starting service work

 Start the procedure after turning off the power and removing the power cord from the outlet.
 Wear an anti-static wrist band or the like whenever possible to remove static electricity of the human
body.
 When removing parts, remove the XERO ASSY if necessary.
 When performing the service operation around the FUSING UNIT, ensure that the FUSING UNIT
and its surrounding area have cooled down sufficiently.
 Pay sufficient attention to the parts during the procedure because they may be broken or may cease
to function properly if unreasonable force is applied.
 Put the removed parts such as TONER CARTRIDGE in a place where they do not affect the service
procedures. (Note that the service procedures can be performed with those parts in place depend-
ing on the target section of removal/replacement.)
 Since various types of screws are used, ensure that the right screws are used in their right positions.
Use special caution not to confuse the screws for plastic and the ones for sheet metal, because
using the wrong type of screws may result in damage to the screw threads or other troubles.
 At the locations with "TAP" marked on the base material and sheet metal, use tap screws for plastic.
No. Type
Screw for
plastic
1
Silver, tap
Screw for
metal sheet
2
Silver
NOTE
Screws you should not loosen are used the special screw.
Never loosen the special screws because the equipment may not operate correctly.
Application Shape
Plastic
Coarse
Parts etc Plastic
Sheet metal
Parts etc Sheet metal
4-3
How to distinguish
Oblique screw-
ing damages the
Silver-colored
thread because
・Thread is coarser
this screw cuts
than that of the
female threads
sheet metal type.
in the base
・Screw tip is thin.
material as it
goes in.
・Silver-colored
・Diameter of the
thread section is
uniform.
Points to be
noted