Fuji Xerox DocuPrint M355df Service Manual page 19

Chapter 1 Service Call Procedure
1.1 Before Starting the Servicing
5 Installing and Removing Parts
Since the edge of parts and covers may be sharp, take care not to touch them. If the oil gets onto your
hand, wipe it off before getting on with the servicing. When pulling out parts or cables, do not yank but
pull gently and gradually.
Do not replace the lithium battery(Lithium metal battery) mounted on the ESS PWB alone.
NOTE
If the terminals of the lithium battery(Lithium metal battery) come in contact with other metal parts, leading
to short circuit, the battery may overheat, burst, or ignite. If the battery alone needs to be collected, the ter-
minals must be covered with adhesive insulation tape or by other means. When collecting the PWB or other
part with the lithium battery(Lithium metal battery) installed, carry the entire part in the packaging materials
(bag/box) for it.
6 Specified Tools
Use the tools for the servicing procedure if any are specified.
7 Cleaning the Toner and Developer
As the toner may cause a dust explosion, sweep the spilt toner into a waste container.
When using a cleaner to clean the remaining toner, be sure to use the FX standard toner-proof cleaner
and not a customer's cleaner.
Also, as the developer also contains toner, exercise the same caution during cleaning.
8 Organic Solvents
When using an organic solvent such as the Drum Cleaner or Machine Cleaner, pay attention to the fol-
lowing:
Ensure good ventilation in the room to prevent too much intake of the solvent.
Do not use heated solvent.
Keep away from fire.
Never throw, use, or store Drum Cleaner or Machine Cleaner in and around fire. Doing so may cause fire
due to flammability. Before disposing of a container of Drum Cleaner or Machine Cleaner, make sure that it
is completely depleted.
9 Modifications
If any modifications are deemed necessary for the printer, submit an Application for Approval of Modifi-
cation prior to performing any work.
1-2