Table of Contents
Advertisement
Chapter 6 General
6.11 Board Diag (Board Test)
Procedure
The procedure below describes [DTMF Send] > [DTMF Continuous] as an example.
1
Enter the CE mode. (See "6.4.2 How to Enter the CE Mode".)
2
Use the [ ] button to select [Fax/Scanner Diag], and then press the [OK] button.
3
Press the [OK] button.
Fax/Scanner Diag
Board Test...
4
Use the [ ] button to select [Relay/Signal Test], and then press the [OK] button.
Board Test
Relay/Signal Test...
5
Use the [ ] button to select [DTMF Send], and then press the [OK] button.
Relay/Signal Test
DTMF Send...
6
Press the [OK] button.
7
Use the [ ] or [ ] button to change the value, and then press the [OK] to start sending the sig-
nal.
DTMF Continuous
DTMF:5
8
To stop sending the signal, press the [
DTMF Continuous
DTMF:0
(Back)] or [
DTMF Continuous
DTMF:5
6-76
Board Test
All test...
Relay/Signal Test
Relay Test...
DTMF Send
DTMF Continuous...
DTMF Continuous
DTMF:5
Now Sending Signal
(Stop)] button.
Advertisement
Chapters
Table of Contents
Troubleshooting
