Fip1.18 075-100 Msi Misfeed Jam - Fuji Xerox DocuPrint M355df Service Manual

Chapter 2 Troubleshooting
2.3 Error Code FIP
FIP1.18 075-100 MSI Misfeed Jam
Step
Parts considered to be the cause
MSI Feed Roll / Nudger Roll [HOLDER ASSY PICK UP]
(PL13.1.15)
KIT RETARD ROLL MSI ASSY(PL13.2.98)
Regi. Sensor [HVPS] (PL18.2.5)
SOLENOID FEED MSI (PL13.1.5)
DRIVE ASSY MAIN (PL3.1.1)
PWBA MCU (PL18.2.2)
Check the paper transport path
1 Is there any foreign substances or bits of paper found on
the paper transport path?
Check the paper feed rolls
2 Are the paper feed rolls (the rolls that are listed among the
parts considered to be the cause) installed properly?
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among the
3
parts considered to be the cause in sequence) deformed or
worn out?
Check the Regi. Sensor [HVPS] operation
Execute the Diag Digital Input [071-102] to check the oper-
4
ation of the Regi. Sensor [HVPS].
Is the Regi. Sensor [HVPS] operating normally?
Check the operation of the SOLENOID FEED MSI
Execute the Diag Digital Output [071-004] to check the
5
operation of the SOLENOID FEED MSI.
Is the SOLENOID FEED MSI operating normally?
Check the operation of the DRIVE ASSY MAIN
Execute the Diag Digital Output [071-001] to check the
6
rotation of the DRIVE ASSY MAIN.
Is it working properly?
Check and Action
2-64
Yes
Remove the
foreign sub-
stances and Go to Step 2.
bits of paper,
etc.
Reinstall the
Go to Step 3. corresponding
paper feed rolls
Replace the
corresponding Go to Step 4.
paper feed rolls
Go to Step 5. Go to FIP2.2
Go to Step 6. Go to FIP2.11
Replace the
PWBA MCU. Go to FIP2.12
(REP 18.2)
No