The Entire Output Is Blank - Fuji Xerox DocuPrint M355df Service Manual

IQ-4

The entire output is blank

Step
Checking the error mode.
1
Does the error occur only during copying?
Checking the original.
2
Is the original placed correctly?
Checking the blank print.
3 Print the Windows test page.
Is the image printed correctly?
Disable the Toner Saver in the printer driver.
On the Image Options tab, ensure that Off is selected in the
4
Toner Saver drop-down menu.
Is the image printed correctly?
Checking the paper.
5 Is the installed paper with a new and dry one? Or does the
paper satisfy the specification?
The toner cartridges may be low or need to be replaced. Con-
firm the amount of toner left in each toner cartridge.
6 1 Check the toner level in the Status Monitor window.
2 Replace the toner cartridges as necessary.
Is the image printed correctly?
Checking the TONER CARTRIDGE.
7 Is the toner cartridges installed to the printer the FUJI XEROX
toner?
Chapter 3 Image Quality Troubleshooting
Possible causative parts
- TONER CARTRIDGE (PL8.1.2)
- Drum Cartridge [XERO ASSY] (PL8.1.1)
- Transfer Unit [ROLL ASSY-TRANS CRU] (PL6.1.1)
- CONNECTOR ASSY XERO (PL5.1.10)
- MOTOR DISP (PL5.1.9)
- ROS ASSY (PL2.1.1)
- PWBA MCU (PL18.2.2)
- HVPS (PL18.2.5)
- PWBA ESS (PL18.1.2)
Check and Action
3-11
3.2 Image Quality Troubleshooting
Yes
Go to step 2.
Go to step 4.
Printing data
form is not suit-
able for the
printer, then
check the print-
ing data which
the problem gen-
erated.
End of work.
Go to step 6.
End of work.
Go to step 9.
No
Go to step 3.
End, set the orig-
inal correctly.
Go to step 4.
Go to step 5.
Replace the
paper with a new
and dry one. Or
change the
paper to the one
that satisfies the
specification,
then go to step 6.
Go to step 7.
Go to step 8.