Chapter 6 General
6.10 Parameter Settings (Parameter)
6.10.2 Display and Initialization of the Life Counter (Life)
Displays or initializes the life counter value of the IOT.
Item
Fusing PV
Fusing Heattime
Trans Unit PV
Drum PV
Life
Drum Thickness
Waste Full Count
Toner Disp Time
Toner Pixel
Toner Gas Gauge
Procedure
The following procedure describes how to change the life counter value of Fusing Heattime as an example.
1
Enter the CE mode. (See "6.4.2 How to Enter the CE Mode".)
2
Confirm that [Printer Diag] is selected, and then press the [OK] button.
3
Use the [ ] button to select [Parameter], and then press the [OK] button.
Printer Diag
Parameter
4
Use the [ ] button to select [Life], and then press the [OK] button.
Parameter
Life
5
Use the [ ] button to select [Fusing Heattime], and then press the [OK] button.
Life
Fusing Heattime
Table 6-44 Life Counter
Displays and initializes the life counter value of Fusing PV.
Displays and initializes the life counter value of Fusing Heattime.
Displays and initializes the life counter value of Trans Unit.
Displays the life counter value of Drum PV.
Displays the life counter value of Drum Thickness.
Displays the life counter value of Waste Full Count.
Displays the life counter value of Toner Disp Time.
Displays the life counter value of Toner Pixel.
Displays the life counter value of Toner Gas Gauge.
6-70
Description
Parameter
Regi
Life
Fusing PV
Fusing Heattime
Read