Fip1.16 071-100 Iot Tray1 Misfeed Jam - Fuji Xerox DocuPrint M355df Service Manual

Chapter 2 Troubleshooting
2.3 Error Code FIP
FIP1.16 071-100 IOT Tray1 Misfeed Jam
Step
Parts considered to be the cause
Tray 1 Feed Roll / Nudger Roll [FEEDER ASSY]
(PL15.3.2)
Tray 1 Retard Roll [HOLDER ASSY RETARD CST]
(PL9.1.3)
Regi. Sensor [HVPS] (PL18.2.5)
CST FEED CLUTCH (PL15.2.16)
DRIVE ASSY MAIN (PL3.1.1)
PWBA MCU (PL18.2.2)
Check the paper transport path
1 Is there any foreign substances or bits of paper found on
the paper transport path?
Check the paper feed rolls
2 Are the paper feed rolls (the rolls that are listed among
the parts considered to be the cause) installed properly?
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among
3
the parts considered to be the cause in sequence)
deformed or worn out?
Check the Regi. Sensor [HVPS] operation
Execute the Diag Digital Input [071-102] to check the
4
operation of the Regi. Sensor [HVPS].
Is the Regi. Sensor [HVPS] operating normally?
Check the CST FEED CLUTCH operation
Execute the Diag Digital Output [071-005] to check the
5
operation of the CST FEED CLUTCH.
Is the CST FEED CLUTCH operating properly?
Check the operation of the MOTOR-ASSY OPTION
(when the Option Tray is installed)
6 Execute the Diag Digital Output [071-009] to check the
rotation of the MOTOR-ASSY OPTION.
Is it working properly?
Check the operation of the DRIVE ASSY MAIN
Execute the Diag Digital Output [071-001] to check the
7
rotation of the DRIVE ASSY MAIN.
Is it working properly?
Check and Action
2-62
Yes
Remove the for-
eign substances
Go to Step 2.
and bits of
paper, etc.
Reinstall the
Go to Step 3. corresponding
paper feed rolls
Replace the
corresponding Go to Step 4.
paper feed rolls
Go to Step 5. Go to FIP2.2
Go to Step 6. Go to FIP2.9
Go to Step 7. Go to FIP2.14
Replace the
PWBA MCU. Go to FIP2.12
(REP 18.2)
No