Fip1.19 077-104 Regi. Off Jam - Fuji Xerox DocuPrint M355df Service Manual

FIP1.19 077-104 Regi. Off Jam
Step
Parts considered to be the cause
ROLL ASSY RUBBER (PL15.2.6)
ROLL ASSY REGI PINCH (PL15.2.8)
ROLL REGI PINCH (PL15.2.37)
Transfer Unit [ROLL ASSY-TRANS CRU] (PL6.1.1)
Drum Cartridge [XERO ASSY] (PL8.1.1)
Regi. Sensor [HVPS] (PL18.2.5)
REGI. CLUTCH (PL15.2.4)
DRIVE ASSY MAIN (PL3.1.1)
PWBA MCU (PL18.2.2)
Check the paper transport path
1 Is there any foreign substances or bits of paper found on
the paper transport path?
Check the paper feed rolls
2 Are the paper feed rolls (the rolls that are listed among the
parts considered to be the cause) installed properly?
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among the
3
parts considered to be the cause in sequence) deformed or
worn out?
Check the Regi. Sensor [HVPS] operation
Execute the Diag Digital Input [071-102] to check the oper-
4
ation of the Regi. Sensor [HVPS].
Is the Regi. Sensor [HVPS] operating normally?
Check the REGI. CLUTCH operation
Execute the Diag Digital Output [071-006] to check the
5
operation of the REGI. CLUTCH.
Is the REGI. CLUTCH operating normally?
Check the operation of the DRIVE ASSY MAIN
Execute the Diag Digital Output [071-001] to check the
6
rotation of the DRIVE ASSY MAIN.
Is it working properly?
Check and Action
2-65
Chapter 2 Troubleshooting
2.3 Error Code FIP
Yes
Remove the
foreign sub-
stances and Go to Step 2.
bits of paper,
etc.
corresponding
Go to Step 3.
Replace the
corresponding
Go to Step 4.
paper feed
rolls
Go to Step 5. Go to FIP2.2
Go to Step 6. Go to FIP2.8
Replace the
PWBA MCU. Go to FIP2.12
(REP 18.2)
No
Reinstall the
paper feed
rolls