Appendix C: Output Types - Pyronix 256 System Manual

P C X S M S A N D P C X 2 5 6 S Y S T E M M A N U A L
Type
0000 Not Used
0001 Fire
0002 Hold Up Any
0003 Intruder Any
0004 Final Arm All*
0005 Misoperation Any (Abort)
0006 Confirmed Any
0007 Tamper Any
0008 Duress
0009 HU Device Any
0010 Gas
0011 Arm Fail
0012 Entry Deviation
0013 Secure Intruder Any
0014 Bell Any
0016 Strobe Any
0017 Omit Rearm Any
0018 Unconfirmed Any
0019 Can All Arm*
0020 Exit Starts All*
NOTE: For 'exit starts' to be entered in system logs, the site option 'Confirmed when...' must be
set to 'exit start'
0021 Exit Starts Any
0022 Final Arm Any
0023 Strobe Set Fail
0025 Keyswitch unset
Set with Omit (Not on
0026
PCX 256)
0031 Entry*
0032 Exit*
0033 Entry/Exit
0034 Lights
Page: 150
A P P E N D I X E :
Active
At alarm
At a HU or Duress alarm
(This includes keypad HU)
At alarm, while system is
disarmed
When system is FULLY armed
When system is silenced after
any 'intruder' output is
triggered
When further input active in
any partition after 'intruder'
alarm
Any tamper alarm
At a Duress alarm (i.e. from a
keypad)
At alarm on a HU input only
At alarm
Pre-set time after start of exit
time, if exit procedure is not
complete
When deviation from entry
route occurs, during entry time
At alarm, after exit time started,
until disarm
When alarm live
When alarm live
At rearm at end of confirm time
if an input in fault is isolated
Any intruder or Tamper alarm
If all inputs and technical faults
in system are clear. Also once
entry time has started
At start of exit time to arm
LAST partition
When exit time starts to arm
FIRST partition
When FIRST partition is armed
Works similar to output 016, but also fires if the set fail timer
expires.
This output turns on for 5 seconds when the system is disarmed
via a keyswitch input (either pulsed or latched keyswitch)
Activates when inputs are omitted on an arming mode
Live during any exit time
Live during any entry time
Live during any entry or exit time
When exit or entry timer starts
O U T P U T T Y P E S
Restore
When a valid code is entered
When a valid code is entered
At first valid code entry
At code entry to disarm
After 2 minutes
At next code entry
At code entry to silence
When a valid code is entered
When a valid code is entered
When a valid code is entered
At code entry to rearm
At code entry to disarm
At first valid code entry
When alarm silenced or when
siren timer expires
When alarm silenced or when
strobe timer expires
When system disarmed
At code entry to silence
If fault exists, and after final
arm
At code entry to disarm FIRST
partition (i.e. no longer fully
armed)
At code entry to disarm LAST
partition
At code entry to disarm LAST
partition
20 seconds after arm/disarm
RINS871-3