P C X S M S A N D P C X 2 5 6 S Y S T E M M A N U A L
1 3 . 1 9 R e v i e w L o g s
There are two logs available on the PCX system:
The Panel Log: Includes all Arm, Disarm and Alarm events. The code holder performing any operation
may be identified by pressing the
access etc.
The Access Log: Includes all Access Control and Guard Tour events. (Not Available on PCX 26/SMS)
With each log, use the
event to the next event that occurred.
To view additional details, press the
next log entry. Pressing the
Information on all fault codes that appear in the log can be seen on page: 143.
13.19.1 Log Entries
The PCX 26/SMS holds up to: 300 log entries
13.19.2 Code Identification
The codes that are entered into the PCX system are identified as follows:
Code
Engineer Code (default 9999)
Master Manager Code (default 5678)
User (Or Manager)
Duress (or Guard)
"Input Switched"
13.19.3 Fault Codes (Device Fail)
Fault codes shown in the system log include numeric code to identify the equipment at which the fault is
present. For example:
Device Fail 203
Mains Fail 400
The first digit identifies the type of device:
1 = Control Panel (PCX 26/SMS or PCX 256)
2 = Keypad (PCX-LCD/UK)
3 = Tag Reader or External Proximity Reader (PCX-PROX/INT and PCX-PROX/EXT)
4 = Remote Input Expander (PCX-RIX8, PCX-RIX8+, PCX-RIX8+/PSU)
5 = Remote Output Expander (PCX-ROX16R)
The remaining digits identify the address of the device, so if the display showed "Device Failure 203", then
there would be a possible wiring fault on the keypad that is addressed as "03". If the display showed "Mains
Failure 400", then the power supply fitted to the RIX addressed as "00" needs to be checked.
Please note a list of all the fault codes and log meanings are shown in Appendix A, page: 143.
Page: 86
key. The panel log also includes all system faults, details of engineer
key to move from one event to the previous event. The
key. If no other information is available, the display will move to the
key will return to the main screen for that entry.
Identity
Engineer
Master Manager
Users 001 to 500 programmed through the Master
Manager menu. (20 user codes for PCX 26/SMS)
Codes 01-20 programmed through the Engineer Menu.
(10 duress codes for PCX 26/SMS)
Key or other switch used through an input
The PCX 256 holds up to: 3000 log entries
key will move from one
RINS871-3