Pyronix 256 System Manual page 90

P C X S M S A N D P C X 2 5 6 S Y S T E M M A N U A L
Enter the number of the inputs you wish to soak test
and press . The input number shows on the
scrolling list. Repeat for each input to be tested. To
remove an input from the list, enter its number again.
Press the key.
Enter the number of days the soak test will last. Press
the key.
Enter the number of days the soak test will revert to in
the event a soak input is triggered during testing.
Press the key. 'Test Control' will be displayed,
press the key.
Test Bell?
To Test the Bell press the
All outputs programmed as either Bell or Strobe will
be tested. Press the
Bell' will be displayed, press the
Do Battery Load Test?
To perform a Battery Load Test, press the
The Battery Load test will be started.
Page: 90
key.
key to stop the test. 'Test
key.
key.
RINS871-3