Table of Contents
Advertisement
In order to program system configurations from the keypad, you must be in the Engineer Menu. The panel
will enter the Engineering Menu after entering a valid engineer code when the panel is in a disarmed state.
Whilst in Engineer Mode all tamper alarms (including case tamper), will be disabled.
3 . 1 E n t e r i n g T h e E n g i n e e r s M e n u
NOTE: You will not be able to access Engineers Mode if partitions or arm levels are armed. The
system must be fully disarmed in order to gain access to the Engineer Menu.
Enter the Engineer Code (default 9999).
Any active faults will be shown. Press
the
key.
"ARM / DISARM SYSTEM?" will be displayed
Press the
key
"FORCE ARM ON 1
displayed
Press the
key
"ENTER CODE" will be displayed
Enter the Engineers code (default 9999)
"INHIBIT FIRE/HU?" will be displayed indicating
that Engineers Mode has been entered.
Once you are in the Engineer Menu, a high pitch tone will be generated regularly to remind you that you are
still in the Engineer Menu.
3 . 2 E x i t i n g T h e E n g i n e e r M e n u
On completion of programming, the system can be returned back to normal mode by:
Use the scroll keys:
"EXIT ENGINEERS MODE"
Press the
key
You will be returned to day mode
When the display shows any main menu item (i.e.
an item shown in capitals) press the
will be returned to day mode.
Please see page: 143, for all fault codes that may appear when exiting the Engineers menu.
RINS871-3
C H A P T E R 3 : T H E E N G I N E E R S M E N U
st
INPUT[01]" will be
and
to scroll to
key, you
P C X S M S A N D P C X 2 5 6 S Y S T E M M A N U A L
METHOD ONE
METHOD TWO
Page: 13
Advertisement
Table of Contents
