Volume Control; Code Stops Sound; E / E Keypads Only; Alert Kps Only - Pyronix 256 System Manual

P C X S M S A N D P C X 2 5 6 S Y S T E M M A N U A L
1 3 . 1 3 V o l u m e C o n t r o l
The Volume Control function applies to the loudspeaker output only. Volume levels at the keypad are
programmed individually – please see page: 41.

13.13.1 Code Stops Sound

If this function is enabled, then once an alarm has been generated (even if the code is not programmed for
that partition) the alarm will be silenced, and a 'Misoperation (Abort) signal' will be sent, but the partition will
still be armed until a valid user that controls that partition is entered.

13.13.2 E / E Keypads Only

If there is a speaker connected to the SPK output of the PCX system the entry and exit tones will be heard
through the speaker. If you would like Entry and Exit tones to be heard on only the keypad and not the
speaker then enable this function.

13.13.3 Alert Kps Only

If this function is enabled then any Alert tones will be heard on the Keypad only and not the speaker.
V i s u a l K e y p a d P r o g r a m m i n g P r o c e d u r e

Volume Control

Using the and
CONTROL? Press the
Partition Volume
Use the numeric keys select the volume level required
for Entry and Exit tones for each partition, once
selected, press the

Alarm

Use the numeric keys to select the volume level
required for Alarm Tones
Press the key
Repeat for Fire, Tamper, Disarmed, Chime and
Intelligent Arm tones. Press the
Code Stops Sound
Enter : for No
Enter : for Yes
Press the key
Page: 72
V O L U M E C O N T R O L
keys, scroll to 'VOLUME
key
key to go to the next.
key
RINS871-3