Packing An Mx10008 Router Or Component For Shipping - Juniper MX10008 Hardware Manual

NOTE: For international or direct-dial options in countries without toll-free numbers, see
https://www.juniper.net/support/requesting-support.html.
If you are contacting JTAC by telephone, enter your 12-digit service request number followed by the
pound (#) key for an existing case, or press the star (*) key to be routed to the next available support
engineer.
The support representative validates your request and issues an RMA number for return of the component.

Packing an MX10008 Router or Component for Shipping

IN THIS SECTION
Packing an MX10008 Chassis for Shipping | 307
Packing MX10008 Components for Shipping | 309
Follow this procedure if you are returning an MX10008 chassis or component to Juniper Networks for
repair or replacement.
Before you pack an MX10008 or component:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD) damage.
See "Prevention of Electrostatic Discharge Damage" on page
Pack your chassis or component using one of these materials:
Use the packing material from the replacement chassis or component
Retrieve the original shipping carton and packing materials
Contact your JTAC representative if you do not have these materials, to learn about approved packing
materials. See "Contacting Customer Support" on page
Ensure that you have the following parts and tools available:
ESD grounding strap.
Electrostatic bag, one for each component.
If you are returning the chassis:
343.
291.
306