Juniper MX10008 Hardware Manual page 59

JNP10K-PWR-AC Power Supply LEDs | 70
JNP10K-PWR-AC2 Power Supply LEDs | 72
JNP10K-PWR-DC Power Supply LEDs | 73
JNP10K-PWR-DC2 Power Supply LEDs | 75
The MX10000 modular routers support AC, DC, high-voltage alternating current (HVAC) and high-voltage
direct current (HVDC) by offering the following power supplies:
JNP10K-PWR-AC
JNP10K-PWR-AC2
JNP10K-PWR-DC
JNP10K-PWR-DC2
All of the power supplies are hot-insertable and hot-removable, field-replaceable units (FRUs). You can
install up to six power supplies in an MX10008 router in the slots labeled PEM 0 through PEM 5 (top to
bottom) located in the rear of the chassis. In the MX10016, you can install up to 10 power supplies in the
slots labeled PEM 0 through PEM 9 (top to bottom) located in the rear of the chassis. You can install the
power supplies in any slot.
The JNP10K-PWR-AC2 and JNP10K-PWR-DC2 power supplies require the enhanced power bus. To
determine whether your system has the standard power bus or the enhanced power bus, see
Status Panel LEDs" on page
supplies.
Table 13: Power Supply Overview
JNP10K-PWR-AC
Maximum 2700 W
output power
Inputs 2 (INP1, INP2)
Compatible Standard
power bus
39. Table 13 on page 60 provides the specifications for these different power
JNP10K-PWR-AC2
5000 W or 5500 W
when set for high power
(30-A); 3000 W when
set for low power (20-A)
2 (INP1, INP2)
Standard or enhanced*
JNP10K-PWR-DC JNP10K-PWR-DC2
2500 W 5500 W when set for
high power (80-A) or
4400 W when set for
low power (60-A)
2 (INP1, INP2) 4 (INPUT 1, INPUT 2)
Standard Standard or enhanced*
60
"MX10008