Juniper MX10008 Hardware Manual page 145

Figure 53: Attaching the Chassis Flange to the Rack
6. Move the lift away from the rack.
7. Attach the chassis to the rack by installing a mounting screw through the open flange holes and rack,
starting from the bottom.
8. Visually inspect the alignment of the router. If the router is installed properly in the rack, all the mounting
screws on one side of the rack are aligned with the mounting screws on the opposite side and the
router is level.
9. After ensuring that the router is aligned properly, tighten the screws using a screwdriver.
10. After you install the mounting screws and securely bolt the chassis to the rack, reinstall the components
in the chassis.
SEE ALSO
Manually Mounting an MX10008 in a 4-Post Rack | 147
MX10008 Site Preparation Checklist | 91
MX10008 Clearance Requirements for Airflow and Hardware Maintenance | 98
Unpacking the MX10008 | 132
Installing the Mounting Hardware | 140
MX10008 Chassis Lifting Guidelines | 319
146