Juniper MX10008 Hardware Manual page 198

7. Rotate the captive screw away from the faceplate of the power supply to release the latch. You can
install the power supplies in any slot labeled PSU 0 through PSU 5 (top to bottom) on an MX10008
and PSU 0 through PSU 9 on a MX10016.
8. Using both hands, place the power supply in the power supply slot on the rear of the system.
9. Slide the power supply straight into the chassis until the power supply is fully seated in the slot. Ensure
the power supply faceplate is flush with any adjacent power supply faceplates or power supply cover
panels (see Figure 95 on page 200
10. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
11. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the router chassis.
Figure 95: Installing a JNP10K-PWR-AC Power Supply in an MX10008
Keep latch in open position during installation.
and Figure 96 on page 201).
200