Juniper MX10008 Hardware Manual page 227

Figure 125: Proper Load Balancing for JNP10K-PWR-DC Power Cables on MX100016
WARNING:
or drape where people can trip on them.
20. Set the enable switches for input 1 and input 2 (see
Set both enable switches to the | (on) position when using both source inputs. When not using source
redundancy, set the unused source to the O (off) position. The LED turns red and indicates an error if
a source input is not in use and the enable switch is | (on).
Ensure that the power cords do not block access to router components
Figure 126 on page 230).
229