Juniper MX10008 Hardware Manual page 271

1. Connect to the router using one of the following methods:
Connect a management device to the console (CON) port on an RCB by following the instructions
in "Connecting an MX10008 Router to a Management Console" on page
Connect a management device to one of the two management (MGMT) ports on the RCB by following
the instructions in "Connecting an MX10008 to a Network for Out-of-Band Management" on page
2. Shut down Junos OS from the external management device by issuing the request vmhost halt
operational mode CLI command. This command shuts down the router gracefully and preserves system
state information. A message appears on the console, confirming that the operating system has halted.
You see the following output (or something similar, depending on the hardware being shut down) after
entering the command:
Shutdown NOW!
System going down IMMEDIATELY
Terminated
Poweroff for hypervisor to respawn
Oct 25 10:35:05 init: event-processing (PID 1114) exited with status=1
Oct 25 10:35:05 init: packet-forwarding-engine (PID 1424) exited with status=8
.
Waiting (max 60 seconds) for system process `vnlru_mem' to stop...done
Waiting (max 60 seconds) for system process `vnlru' to stop...done
Waiting (max 60 seconds) for system process `bufdaemon' to stop...done
Waiting (max 60 seconds) for system process `syncer' to stop...
Syncing disks, vnodes remaining...0 0 0 0 done
syncing disks... All buffers synced.
Uptime: 11h0m30s
Normal shutdown (no dump device defined)
unloading fpga driver
unloading fx-scpld
Powering system off using ACPI
kvm: 28646: cpu0 disabled perfctr wrmsr: 0xc1 data 0xabcd
pci-stub 0000:01:00.2: transaction is not cleared; proceeding with reset anyway
pci-stub 0000:01:00.1: transaction is not cleared; proceeding with reset anyway
hub 1-1:1.0: over-current change on port 1
Stopping crond: [
Stopping libvirtd daemon: [
Shutting down ntpd: [
Shutting down system logger: [
Shutting down sntpc: [
Stopping sshd: [
OK ]
OK ]
OK ]
OK ]
OK ]
OK ]
166.
165.
273