Juniper MX10008 Hardware Manual page 167

New password: password
Retype new password: password
6. (Optional) Configure the name of the router. If the name includes spaces, enclose the name in quotation
marks (" ").
[edit]
root@# set system host-name host-name
7. Configure the default gateway.
[edit]
root@# set routing-options static route default next-hop address
8. Configure the IP address and prefix length for the router management interface.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
CAUTION:
interfaces within the same subnet, only one interface is usable and supported.
NOTE: The management ports, em0 (MGMT for RJ-45 connections) and em1 (also labeled
MGMT for fiber connections), are found on the port panel of the RCBs of the MX10008 router.
9. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
10. Enable Telnet service.
[edit]
root@# set system services telnet
Although the CLI permits you to configure two management Ethernet
168