Juniper MX10008 Hardware Manual page 238

14. Using both hands, place the power supply in the power supply slot on the rear of the router. Slide the
power supply straight into the chassis until the power supply is fully seated in the slot. The power
supply will protrude from the chassis about 2 in. (5 cm) (see
Figure 138 on page 241).
15. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
16. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the router chassis.
Figure 137: Installing a JNP10K-PWR-DC2 in an MX10008
Figure 137 on page 240
240
and