Juniper MX10008 Hardware Manual page 80

Figure 39: Routing and Control Board LEDs
1 2
1 Routing and Control Board status panel
—
2 Solid State Disk (SSD) LEDs—DISK1 and DISK2
—
Table 21 on page 81 describes the LEDs on the RCB status panel.
Table 21: Routing and Control Board Status LEDs
LED
PWR
STS
MST
Figure 40 on page 82 shows the management port LEDs on the RCB.
3
Color State
Green On steadily
Yellow Blinking
Dark Unlit
Green On steadily
Green Blinking
Yellow On steadily
Yellow Blinking
Dark Unlit
Green On steadily
Dark Unlit
3 Clock LEDs–BITS-0, and BITS-1
—
Description
RCB is receiving adequate power.
An error has been detected in the RCB.
RCB is not powered up.
RCB is online and functioning correctly.
The beacon feature is enabled.
The RCB is booting.
An error has been detected in the RCB.
The power supply is switched off.
The RCB is the master.
The RCB is the backup.
81