Juniper MX10008 Hardware Manual page 210

NOTE: You can install the power supplies in any slot labeled PSU 0 through PSU 5 (top to
bottom) on an MX10008, and PSU 0 through PSU 9 on a MX10016.
8. Using both hands, place the power supply in the power supply slot on the rear of the system. Slide the
power supply straight into the chassis until the power supply is fully seated in the slot. Ensure the
power supply faceplate is flush with any adjacent power supply faceplates or power supply cover panels
(see Figure 108 on page 212
9. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
10. Tighten the captive screw by turning it clockwise by using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the router chassis.
Figure 108: Installing JNP10K-PWR-AC2 in an MX10008
and Figure 109 on page 213).
212