Juniper MX10008 Hardware Manual page 87

Software features Supports rate selectability at the port level.
By default, the ports are configured as 10-Gigabit Ethernet ports.
Optical diagnostics and related alarms.
Power requirements Line-rate throughput of 4.0 Tbps:
Power consumption at different temperatures:
25° C: 1335 W
40° C: 1425 W
LEDs OK/FAIL LED:
Steady green—MPC is functioning normally.
Yellow—MPC has failed.
Port LED—Link
Off—Port is not enabled.
Green—Port link is up with no alarms or failures.
Red—Port link is down with alarms.
NOTE:
10-Gigabit port is indicated with the addition of four LEDs provided on the line card. The lane LEDs for the
corresponding port indicates the port status.
Like the port status LED, each individual lane LED support four states as: OFF, AMBER, GREEN, RED. See MPC and
MIC Lane LED Scheme Overview for more details.
For the 40-Gigabit mode the lane number LED is not applicable. The port LED indicates the port status, irrespective
of whichever lane number LED is ON.
Cables and TIP:
connectors on your Juniper Networks device.
The list of supported transceivers for the MX Series is located at
When a QSFP+ port is configured for the 10-Gigabit mode with a breakout cable, the link status for the
You can use the Hardware Compatibility Tool to find information about the pluggable transceivers supported
MX Series Supported
88
Transceivers.