Juniper MX10008 Hardware Manual page 192

4. Remove the power cords from the AC inlet on the AC power supply faceplate.
5. Turn the adjustment nut of the power cord retainers counterclockwise until you can see the power
cord. Pull the power cord from the slot in the adjustment nuts.
6. Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver, number 1. See
Figure 89 on page 195
7. Rotate the captive screw away from the faceplate of the power supply to release the latch.
8. Taking care not to touch the power supply output connections, pins, leads, or solder connections, place
one hand under the power supply to support it. Grasp the power supply handle with your other hand
and pull the power supply completely out of the chassis.
CAUTION:
it could damage the power supply.
CAUTION:
a few minutes for the power supply to cool by pulling the power supply halfway out
of the chassis, or wear protective, heat-resistant gloves while removing the power
supply.
9. If you are not replacing the power supply, install the cover panel over the slot by inserting your thumb
and forefinger into the finger holes, squeezing and pulling the cover out of the slot.
and Figure 90 on page 195.
Do not bump the output connections. If the connection hits a solid object,
See the heat symbol . The power supply surfaces are hot. Allow
194